Apollo Twin & Apollo Twin MkII Mac Installation, Registration & Authorization

Note: The information in this article applies to both Apollo Twin and Apollo Twin MkII. 

The steps below will guide you through the process of installing the UAD software, registering your Apollo Twin, and authorizing your UAD plug-ins.

  1. Connect and power Apollo Twin

    Before installing the UAD software, connect your Apollo Twin to a Thunderbolt port on your Mac with a Thunderbolt cable, then power on the Apollo Twin.

  2. Download the UAD software

    Registration and authorization is managed by the UAD software. Download the latest UAD software installer here: www.uaudio.com/download

  3. Install the UAD software

    Open the UAD software installer after the download is complete. The installer will guide you through the process. Be sure to restart the computer when prompted. 

    Note: If the "Firmware Update" prompt appears, click Load and follow the on-screen instructions to complete the process.

  4. Register your Apollo Twin

    After restarting, your web browser will launch and connect to the UA website. You will be prompted to create an account or log in to an existing account (if not already logged in). Follow the instructions on the web pages to register your Apollo Twin and claim the bundled UAD plug-ins.

    Note: If your web browser doesn't launch automatically, you can start the process manually by clicking the Authorize Plug-Ins button on the Plug-Ins panel in the UAD Meter & Control Panel.

  5. Authorize your Apollo Twin

    After registration is complete, authorize your Apollo Twin by clicking the Authorize Plug-Ins button on the Plug-Ins panel in the UAD Meter & Control Panel.

    Screen_Shot_2017-03-14_at_9.32.19_AM.png

    Once authorization is complete the system is ready for use. 
Was this article helpful?
1 out of 5 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk