High Resolution Sample Rate Exceptions

UAD Plug-Ins that can exceed DSP at 176.4 kHz and 192 kHz sample rates

• UAD LA-6176 Signature Channel Strip - Stereo instances will exceed the DSP at 176.4 kHz and 192 kHz when DSP LoadLock is enabled or, with DSP LoadLock disabled, when its Dyn Mode parameter is set to 1176.

UAD Plug-Ins that can exceed DSP with SOLO Core UA audio interfaces 

Due to the DSP footprint for Realtime UAD Processing with SOLO core (single SHARC) UA audio interfaces, the following sample rate exceptions apply with Arrow, Apollo SOLO, Apollo SOLO USB, Apollo Twin SOLO, and Apollo Twin MkII SOLO interface models.

• UAD Capitol Chambers and UAD Hitsville Reverb Chambers can be loaded at sample rates of 44.1 kHz and 48 kHz. These plug-ins have limited compatibility at higher sample rates. It is possible to run these plug-ins on Arrow/Apollo SOLO at 96 kHz, but Input Delay Compensation must be disabled and all input and virtual channels in Console must be stereo-linked.
• UAD Thermionic Culture Vulture cannot be loaded on stereo tracks in a DAW at sample rates of 88.2, 96, 176.4, or 192 kHz if Console's Input Delay Compensation is enabled. If Console's Input Delay Compensation is disabled, the limitation applies only at 96 kHz.
• UAD Neve 1073 and UAD Neve 1084 cannot be loaded onto stereo tracks in a DAW when the sample rate is set to 176.4 or 192 kHz if the plug-in's EQ section is enabled in the GUI or DSP LoadLock is enabled in the UAD Meter & Control Panel app.

UAD Plug-Ins that do not support 176.4 kHz and 192 kHz sample rates

Some UAD plug-ins do not support sample rates of 176.4 kHz and 192 kHz. These plug-ins are listed in the table below.